Make An Earring Holder

Here's a stylish little earring holder you can make quite simply!! And, it even includes *burlap* (que crafters fainting). It's a great way to display your earrings. And, it helps to remind you of earrings you may have overlooked....

Alright, here's the list of supplies:

Wire Mesh (by the roll at Agway)

Burlap

Ribbon
Picture Frame

Hot Glue

Tiny Nails (to tack down the mesh)

~Take the wooden frame and measure some mesh to fit over it, no overlapping (it would cause sharp edges).

~With the frame right side facing up, tack the wire down with the tiny nails in the corners to help secure it. 

~ Trim out a piece of burlap to cover the back of the frame (optional....I made two different holders, one with burlap behind and one without and I liked them both the same) and hot glue it into place. 

~Trim some burlap into long 2" wide lengths.

~Lay the lengths down on the front of the frame, over the wire, and make pleats (every two inches or so) and use the hot glue to hold them in place on the frame. 

~Glue some of the ribbon over the inside edge.

You're done!!

Shared this at these: